Maintenance of Concrete Batching Plants Mixing System
Brief Introduction：Maintenance of concrete batching plants mixing system should pay attention checking the shaft end seal cavity whether the import and export of distributor and sealing pipeline is smooth and full of grease
1. Check the shaft end seal cavity. Whether the import and export of distributor and sealing pipeline is smooth and full of grease. Whether each lubrication point and the reduction gear box has enough lubricating oil.
2. Observe whether grease in electric lubrication pump oil barrel are empty. Near-empty must fill in time and disallowed to run without oil.
3. Must be fully cleaned accumulated material inside and outside for mixing tube and discharge doors and rinse with water. Can not rinse should use mechanical chisel away.
4. The mixing blades must be tightened and tightened once a week to prevent the blades from falling off and causing an accident.
Through the above methods for the concrete batching plants mixing system maintenance, can make the concrete batching plants service life longer.
