Debugging of Concrete Batch Plants
Brief Introduction: In the debugging of concrete batch plants must be more than click the ingredients button to see whether the flexibility and can configure the accuracy, and then adjust the ingredients reference
Debugging of concrete batch plants is also an essential step after the installation of the concrete batch plants. Next I will explain to you about the debugging steps.
1. When debugging the control system, first reset the emergency button, close the power switch in the electrical cabinet, turn on the branch circuit breaker, control circuit power switch, control room power switch, observe the electrical system is abnormal;
2. Open the various motor buttons, test drive motor steering is correct, if not correct should be adjusted immediately;
3. Start the concrete batch plants pump, until the pressure to meet the requirements in accordance with the button marked in order to start the gas control door, check whether the action is flexible; the computer to adjust the zero and sensitivity;
Check the air compressor switch is normal, barometer shows correct, the safety valve pressure adjustment to the standard range;
4. Operation
stationary concrete mixer, to see whether abnormal sound, the various components are working properly;
5. Running belt machine debugging, in the operation of the process to check whether the flexible operation of the various rollers, to carefully observe the belt, can not have swing, deviation, milling, skidding, deformation, etc.;
6. In the debugging of concrete batch plants must be more than click the ingredients button to see whether the flexibility and can configure the accuracy, and then adjust the ingredients reference.